Free Shipping Magnetic Speed Sensor for GAC MSP678 Pick Up

Part Number: MSP678

Specification:

• Rotate speed sensor,
• speed sensor,
• generator sensors
• Item: MSP678
• Pickup Length: 5.00"
• Thread Length: 4.75"
• Overall Length: 6.125"
• Thread Size: 5/8-18 UNF-2A
• Drill Size: 37/64

Introduction:
*The magnetic speed sensor indicates when ring gear teeth, or other ferrous projections, pass the tip of the sensor.
*Electrical impulses are induced within the coil and sent to the speed control unit. The signal from the magnetic speed Sensor, teeth per second(HZ), is directly proportional to engine speed.

Description:
*The magnetic speed sensor is mounted in the ring gearcase or flywheel bell housing of the engine.
*The threaded hole for the speed sensor should be perpendicular to the centerline of the crankshaft and centered over the ring gear teeth.
*A spot face should be present to provide a flat surface on which to anchor the lock nut.
*With the engine stopped, screw the speed sensor in until it touches a gear tooth, then back it out 3/4 of a turn and secure it with the lock nut.
*Any ferrous gear may be used as long as the frequency and amplitude of the resulting signal meet the speed control unit specifications
*The wire leads should be twisted for their entire length from the magnetic speed sensor to the control unit.
*The leads may need shielding if they are longer than 10ft. (3m), or if external interference is present.
*Do not connect either of the speed sensors leads to anything but the speed control unit used. The shield should not be connected at the speed sensor end.